1, the operator must be familiar with the structure and performance of the
plate shearing machine
. Cutting machine for the majority of people at the same time, it must be responsible for the production of a person in charge of command.2, do not put their hands in between the upper and lower blade, to avoid the accident.
3, all debris, do not put on the table, to avoid rolling into the edge of the accident. Should regularly check the sharp knife edge case, if found blade with a blunt, should be timely to sharpen or exchange, blade sharpening only the thickness of the blade grinding.
4, should regularly check the cutting machine parts, in order to maintain the machine and the surrounding area clean, cable insulation is good.
5, installed on the oil pump oil filter oil filter should always check the cleaning, so that the oil filter to maintain the proper amount of oil. If the filter is blocked, the amount of oil will be reduced, so that the oil pump will suck, affecting the life of the oil pump.
6, the return cylinder pressure is low, the return cylinder can be inflated. The method is to remove the protective cap and the air valve cap, and to install the charging tool, and the other end of the gas filling tool is connected with the nitrogen gas bottle (no oxygen). Turn off the load cylinder stop valve immediately to 6.0MPa. Close the inflation tool, open the inflation tool, install the valve cap and the protective cap.
1) the first is to turn on the power, in the control panel to open the key switch, and then press the pump to start, so you will hear the sound of the oil pump. (the machine does not move at this time)
2) travel adjustment, use must pay attention to adjust the stroke, before bending must test. Its upper die down to the bottom must be guaranteed to have a thickness of the gap. Otherwise it will cause damage to the mold and machine of Yangcheng Lake hairy crabs. Stroke adjustment is also a fast electric adjustment and manual adjustment of the stomach.
3) bending notch, notch in general to choose the thickness 8 times the width of the. Such as plate bending 4mm, need to choose about 32 slot.
4) after the adjustment of the general electric fast adjustment and manual adjustment, the same method with plate cutting machine.
5 foot pedal switch began to bend, CNC bending machine dies and plate shearing machine is different, can be at any time to loosen, loosen the foot will stop, continue to step down. Plastic CNC bending machine tooling, plastic folding machine, plastic board, CNC bending machine tooling, direct plastic sheet plastic bending sheet metal bending, without mosaic, does not need to be slotted, welding is not needed, it folded angle has the advantages of beautiful appearance without leakage, it will change to fulfill the automatic machine operation manual welding, improves the quality, improves the working efficiency, reduces the labor cost, shortens the production cycle of the product. Full automatic plastic bending machine is a kind of electric integrated automatic mechanical equipment.
